We're so confident of our products that we provide no hassle product exchange.
IBM AnyPlace Kiosk Models 5xx 7xx and 9xx Technical Mastery (P6040-015) Sample Questions:
1. Which four devices are supported in the integrated ExpressCard slot? (Choose four.)
A) stereo speakers
B) TV Tuner
C) wireless WAN card
D) MSR
E) 1394/Firewire
F) PCMCIA to ExpressCard converters
G) 3D Graphics
2. When utilizing the IBM AnyPlace POS Hub, where does the IBM AnyPlace Kiosk get its power?
A) an external power supply
B) the AnyPlace POS Hub to which it is connected
C) a lithium ion battery
D) its own integrated power supply that is plugged into a wall outlet
3. What are the three maintenance practices for the IBM AnyPlace Kiosk? (Choose three.)
A) make sure to use a small fan near it to promote air circulation if the Kiosk is wall mounted
B) avoid powering off the system unit while performing cleaning procedures
C) use isopropyl alcohol to safely remove tape adhesive from plastics
D) avoid blocking the air vents on the sides and back of the Kiosk
E) avoid using scouring pads and petroleum-based solvents
F) use spray glass cleaner to clean the touch screen and the plastics about every three months
4. Which two IBM AnyPlace Kiosk peripherals are attached via device-specific ports? (Choose two.)
A) AnyPlace Line or Omni Scanner
B) MSR
C) keyboard
D) printer
E) cash drawer
5. There are special precautions to follow for handling static-sensitive components such as printed circuit boards. What
are four applicable precautionary steps? (Choose four.)
A) keep one finger in contact with the metal frame at all times
B) once the component is removed from the anti-static bag, install it immediately
C) lessen the amount of static electricity by limiting the amount of movement made
D) when putting the component down, set it on top of an anti-static bag, not on the system cover or metal table
E) wear rubber gloves to reduce static electricity and prevent cutting fingers from the sharp edges
F) stand with at least one foot on an anti-static mat when installing printed circuit boards
G) when handling the board, touch it only on the frame or edges
Solutions:
| Question # 1 Answer: B,C,E,F | Question # 2 Answer: B | Question # 3 Answer: C,D,E | Question # 4 Answer: A,B | Question # 5 Answer: B,C,D,G |
By Vera
