[2021] 350-601 All-in-One Exam Guide Practice To your 350-601 Exam!
Preparations of 350-601 Exam 2021 CCNP Data Center Unlimited 139 Questions
NEW QUESTION 79
A network engineer must deploy a configuration backup policy to the cisco UCS manager. The file generated from this backup must have a snapshot of the entire system that should be used to restore the system during disaster recovery. The backup file must be transferred insecurely by using the TCP protocol. Which configuration backup settings meet these requirements?
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: B
NEW QUESTION 80
An engineer is configuring VNTag between a virtualized server and a Cisco Nexus 5500 Series switch. Drag and drop the configuration steps from the into the correct order on the right.
Answer:
Explanation:
Explanation
install the virtualization feature set
Enable the virtualization feature set
Configure the port profile
Configure support for VNTag mode on the interface that connects to the server.
Configure the server to support NIV mode
Configure the vNICs of the server
NEW QUESTION 81
An engineer is enabling port security on a Cisco MDS 9000 Series Switch.
Which feature of enabling port security on a Cisco MDS 9000 Series Switch must be considered?
- A. It can be distributed by using Cisco Fabric Services.
- B. It always learns about switches that are logging in.
- C. It authorizes only the configured sWWN to participate in the fabric.
- D. It binds the fabric at the switch level.
Answer: A
NEW QUESTION 82
Refer to the exhibit.
Which statement about the default gateway configuration of the vPC is true?
- A. N7K-2 forwards traffic that is destined for the default gateway by using the peer link.
- B. N7K-2 acts as the default gateway for all traffic.
- C. N7K-1 acts as the default gateway for all traffic.
- D. Either switch can act as the active default gateway.
Answer: D
Explanation:
Section: Network
NEW QUESTION 83
Refer to the exhibit.
Which action is taken to ensure that the relay agent forwards the DHCP BOOTREQUEST packet to a DHCP server?
- A. Configure the IP address of the DHCP server.
- B. Verify the DHCP snooping bindings.
- C. Configure the interface of the DHCP server as untrusted.
- D. Enable the DHCP relay agent.
Answer: D
NEW QUESTION 84
Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency?
A)
B)
C)
D)
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: B
NEW QUESTION 85
A network engineer configures a converged network adapter (CNA) and must associate a virtual fiber Channel
7 interface to VSAN 7. The CAN connected to the interface Eth1/7, and VLAN 700 is mapped to the VSNA.
Which configuration must be applied to create the virtual Fiber Channel interface and associate it with the Ethernet physical interface?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 86
Drag and drop the mechanisms to collect data from a network from the left onto their characteristics on the right
Answer:
Explanation:
NEW QUESTION 87
An engineer is enabling port security on a Cisco MDS 9000 Series Switch. Which feature of enabling port security on a Cisco MDS 9000 Series Switch must be considered?
- A. It authorizes only the configured sWWN to participate in the fabric.
- B. It always learns about switches that are logging in.
- C. It can be distributed by using Cisco Fabric services.
- D. It binds the fabric at the switch level.
Answer: B
NEW QUESTION 88
Refer to the exhibit.
Which VLANs are capable to be assigned on vPC interfaces?
- A. 100-102
- B. 100-105
- C. 100-104
- D. 100-103
Answer: B
NEW QUESTION 89
What is an advantage of using Ansible for automation as compared to Puppet and Chef?
- A. Ansible abstracts a scenario so that one set of configuration settings can be used across multiple operating systems.
- B. Ansible performs automation without installing a software agent on the target node.
- C. Ansible automates the enforcement of configuration settings.
- D. Ansible configures a set of CLI commands on a device by using NETCONF.
Answer: B
Explanation:
Section: Automation
NEW QUESTION 90
Refer to the exhibit.
Why does the python code for Cisco NX-API print error message?
- A. The "type" is wrong in the header of the request and should be "cli_ conf".
- B. NX-API does not allow configuration for features via the requests module.
- C. The "type" is wrong is the body of the request and should be "cli_ conf".
- D. The JSON is not a supported format for the NX-API.
Answer: C
NEW QUESTION 91
Refer to the exhibit.
A flapping link issue has been reported on the vPC keepalive link. A packet capture has been activated on the Cisco Nexus switch. What is the destination IP address of the vPC keepalive packets that are sent by the switch?
- A. 192.168.254.1
- B. 192.168.254.2
- C. 239.255.70.83
- D. 192.168.254.4
Answer: D
NEW QUESTION 92
Which statement about the MAC address that the FCoE Initialization Protocol chooses for use by an E-Node in an FCoE implementation is true?
- A. The FCoE Initialization Protocol uses the burned-in MAC address of the converged network adapter for all FCoE operations.
- B. The FCoE Initialization Protocol uses 01.00.0C as the first 24 bits of the MAC address and appends a 24-bit Fibre Channel ID to derive a full 48-bit FCoE MAC address.
- C. FCoE does not use a MAC address. The FCoE Initialization Protocol is used to acquire a Fibre Channel ID, and the address is used for all FCoE communications in the same way as Fibre Channel Protocol.
- D. The FCoE Initialization protocol uses a 24-bit FC-MAP and concatenates a 24-bit Fibre Channel ID to create a fibric-provided MAC address.
Answer: C
NEW QUESTION 93
An engineer changed a configuration and must perform a rollback. Which statement applies to a Cisco Nexus 5600 Series switch?
- A. A user who is assigned to the network-operator user role can perform a rollback.
- B. The configuration rollback functionality is disabled when FCoE is enabled.
- C. Errors are skipped when an atomic rollback type is triggered.
- D. A system checkpoint is generated automatically when the running configuration is saved to NVRAM.
Answer: B
NEW QUESTION 94
When the default firmware package is set to a new version, which type of policy determines the liming of server reboots during the firmware upgrade?
- A. BIOS
- B. local disk
- C. diagnostics
- D. maintenance
Answer: D
Explanation:
Explanation
NEW QUESTION 95
......
Focus on 350-601 All-in-One Exam Guide For Quick Preparation: https://www.surepassexams.com/350-601-exam-bootcamp.html
Practice To 350-601 - SurePassExams Remarkable Practice On your Implementing and Operating Cisco Data Center Core Technologies Exam: https://drive.google.com/open?id=1vv2k_sREQE5ivIVBikgCEbeSpf0ppRj4