Get HPE6-A72 Braindumps & HPE6-A72 Real Exam Questions [Q44-Q64]

Share

Get HPE6-A72 Braindumps & HPE6-A72 Real Exam Questions

HP HPE6-A72 Actual Questions and Braindumps

NEW QUESTION 44
Refer to the exhibit.

The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports.
Which ports carry VLAN 1 traffic?

  • A. 1/1/1-1/1/24
  • B. 1/1/8-1/1/10, 1/1/5-1/1/28
  • C. 1/1/8, 1/1/10, 1/1/5-1/1/24
  • D. 1/1/1-1/1/28

Answer: B

 

NEW QUESTION 45
Core# configure terminal
Core(config)# vrf Green
Core(config-vrf)# exit
Core(config)#
Core(config)# interface vlan 50
Core(config-if-vlan)# ?
Given the configuration on the CORE switch shown above, what command would follow to assign the switched virtual interface (SVI) vlan 50 to the VRF created?

  • A. Core(config-if-vlan)# vrf attach Green
  • B. Core(config-if-vlan)# ip vrf forwarding Green
  • C. Core(config-if-vlan)# routing-context Green vrf
  • D. Core(config-if-vlan)# ip vpn-instance Green

Answer: A

 

NEW QUESTION 46
Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?

  • A. Aruba 8400
  • B. Aruba 5412r
  • C. Aruba 6410
  • D. Aruba 8408

Answer: A

 

NEW QUESTION 47
What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

Answer: B

 

NEW QUESTION 48
Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?

  • A. Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.181
  • B. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.1
  • C. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.181
  • D. Host-B: assign the default-gateway address 10.1.20.181

Answer: C

 

NEW QUESTION 49
Which two statements accurately describe stacking with Aruba switches? (Choose two.)

  • A. The VSF feature is not compatible between AOS-CX and AOS platforms.
  • B. VSF and VSX are stacking option with the AOS-CX 8320. 8325. 8400. and 6400 models.
  • C. VSF is a core or aggregation layer stacking technology due to the high resiliency of sharing a single control plane.
  • D. A VSF stack is allowed between an AOS-CX 6300M and 6300F switches.
  • E. A VSF stack is allowed between an AOS 5400R and an AOS-CX 6400.

Answer: B,C

 

NEW QUESTION 50
Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?

  • A. Lightweight Access Point Protocol (LWAPP)
  • B. Process Application Programming Interface (PAPI)
  • C. Generic Routing Encapsulation (GRE)
  • D. Control and Provisioning of Wireless Access Points (CAPWAP)

Answer: C

 

NEW QUESTION 51
Refer to the exhibit.

Which command produces the above output?

  • A. show interface port 1/1/10 switchport
  • B. show trunk port 1/1/10 extended
  • C. show vlan port 1/1/10
  • D. show interface port 1/1/10 trunk

Answer: B

 

NEW QUESTION 52
What are the commands to disable SSH and HTTPS services from the default VRF?

  • A. Core-1(config)# no ssh server vrf default Core-1(config)# no https-server vrf default
  • B. Core-1(config)# no ssh server enable Core-1(config)# no https-server enable
  • C. Core-1(config)# no ssh server Core-1(config)# no https-server
  • D. Core-1# no ssh server vrf default Core-1# no https-server vrf default

Answer: A

 

NEW QUESTION 53
What are two methods for remotely managing an Aruba AOS-CX switch? (Choose two.)

  • A. SNMPv2c
  • B. Telnet
  • C. USB-C console
  • D. HTTPS
  • E. SSH

Answer: D,E

 

NEW QUESTION 54
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

  • A. Option B
  • B. Option C
  • C. Option A
  • D. Option D

Answer: D

 

NEW QUESTION 55
Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)

  • A. Aruba 8400
  • B. Aruba 2930F
  • C. Aruba 8350
  • D. Aruba 5406R
  • E. Aruba 6405

Answer: A,E

 

NEW QUESTION 56
The following command is issued:
Switch# checkpoint rollback start
What is the result?

  • A. The switch will use the checkpoint 'rollback1 as the starting configuration on next reboot.
  • B. The command will fail because it is incomplete.
  • C. The switch will revert the running-configuration to the checkpoint called 'start1 without a reboot.
  • D. The command will fail because rollback commands must be issued from global-config mode.

Answer: C

 

NEW QUESTION 57
Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?

  • A. show interface gigabit 1/1/1
  • B. show interface 1/1/1
  • C. show interface vlan 1111
  • D. show vlan 1111

Answer: B

 

NEW QUESTION 58
Refer to the exhibit.

The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches. What is the output of this command?

  • A. Option B
  • B. Option C
  • C. Option A
  • D. Option D

Answer: D

 

NEW QUESTION 59
Refer to the exhibit.

What command (output shown above) gives the optics serial number and part number information?

  • A. show interface transceiver
  • B. show interface optics
  • C. show interface physical
  • D. show inventory

Answer: A

 

NEW QUESTION 60
Refer to the exhibit.

All switches are running Aruba OS-CX. While working in the terminal of Access-2, you are unable to reach Server-1 using SSH.
What is the correct command to ping Server-1 from Access-2 to test reachability?

  • A. Access-2# ping6 172.16.1.97 vrf mgmt.
  • B. Access-2# ping 172.16.1.97
  • C. Access-2# ping 172.16.1.97 vrf mgmt
  • D. Access-2# ping 172.16.1.97 vrf default

Answer: C

 

NEW QUESTION 61
Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

  • A. copy config config1 config startup-config
  • B. copy running-config startup-config
  • C. copy running-config checkpoint boot-config
  • D. write memory
  • E. save

Answer: B,D

 

NEW QUESTION 62
Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

Answer:

Explanation:

 

NEW QUESTION 63
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

  • A. Option B
  • B. Option C
  • C. Option A
  • D. Option D

Answer: D

 

NEW QUESTION 64
......

HPE6-A72 Dumps To Pass HP Exam in 24 Hours - SurePassExams: https://www.surepassexams.com/HPE6-A72-exam-bootcamp.html

Buy Latest HPE6-A72 Exam Q&A PDF - One Year Free Update: https://drive.google.com/open?id=1dvOWwjKMEK-f4tbiilXvLlRzYvfN5-W8