Verified NSE6_FWF-6.4 Exam Dumps PDF [2023] Access using SurePassExams
Try Best NSE6_FWF-6.4 Exam Questions from Training Expert SurePassExams
NEW QUESTION 12
Which statement describes FortiPresence location map functionality?
- A. Provides real-time insight into user movements
- B. Provides real-time insight into user usage stats
- C. Provides real-time insight into user purchase activity
- D. Provides real-time insight into user online activity
Answer: B
Explanation:
This geographical data analysis provides real-time insights into user behavior.
NEW QUESTION 13
Which statement is correct about security profiles on FortiAP devices?
- A. FortiGate performs inspection the wireless traffic
- B. Disable DTLS on FortiAP
- C. Only bridge mode SSIDs can apply the security profiles
- D. Security profiles on FortiAP devices can use FortiGate subscription to inspect the traffic
Answer: C
NEW QUESTION 14
Where in the controller interface can you find a wireless client's upstream and downstream link rates?
- A. On the AP CLI, using the cw_diag ksta command
- B. On the AP CLI, using the cw_diag -d sta command
- C. On the controller CLI, using the diag wireless-controller wlac -d sta command
- D. On the controller CLI, using the WiFi Client monitor
Answer: C
NEW QUESTION 15
When using FortiPresence as a captive portal, which two types of public authentication services can be used to access guest Wi-Fi? (Choose two.)
- A. Hardware security token authentication
- B. Social networks authentication
- C. Software security token authentication
- D. Short message service authentication
Answer: A,B
Explanation:
This information along with the social network authentication logins with Facebook, Google, Instagram, LinkedIn, or FortiPresence using your WiFi.
Captive Portal configurations for social media logins and internet access. You can add and manage sites using the integrated Google maps and manoeuvre your hardware infrastructure easily.
NEW QUESTION 16
You are investigating a wireless performance issue and you are trying to audit the neighboring APs in the PF environment. You review the Rogue APs widget on the GUI but it is empty, despite the known presence of other APs.
Which configuration change will allow neighboring APs to be successfully detected?
- A. Ensure that all allowed channels are enabled for the AP radios.
- B. Enable Locate WiFi clients when not connected in the relevant AP profiles.
- C. Enable Radio resource provisioning on the relevant AP profiles.
- D. Enable Monitor channel utilization on the relevant AP profiles.
Answer: C
Explanation:
The ARRP (Automatic Radio Resource Provisioning) profile improves upon DARRP (Distributed Automatic Radio Resource Provisioning) by allowing more factors to be considered to optimize channel selection among FortiAPs. DARRP uses the neighbor APs channels and signal strength collected from the background scan for channel selection.
NEW QUESTION 17
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit C
A wireless network has been installed in a small office building and is being used by a business to connect its wireless clients. The network is used for multiple purposes, including corporate access, guest access, and connecting point-of-sale and IoT devices.
Users connecting to the guest network located in the reception area are reporting slow performance. The network administrator is reviewing the information shown in the exhibits as part of the ongoing investigation of the problem. They show the profile used for the AP and the controller RF analysis output together with a screenshot of the GUI showing a summary of the AP and its neighboring APs.
To improve performance for the users connecting to the guest network in this area, which configuration change is most likely to improve performance?
- A. Install another AP in the reception area to improve available bandwidth
- B. Enable frequency handoff on the AP to band steer clients
- C. Reduce the number of wireless networks being broadcast by the AP
- D. Increase the transmission power of the AP radios
Answer: D
NEW QUESTION 18
What type of design model does FortiPlanner use in wireless design project?
- A. Predictive model
- B. Architectural model
- C. Analytical model
- D. Integration model
Answer: B
Explanation:
FortiPlanner will look familiar to anyone who has used architectural or home design software.
NEW QUESTION 19
Refer to the exhibit.
If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?
- A. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.
- B. Areas with the signal strength weaker than -68 dB are cut out of the map
- C. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
- D. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
Answer: D
NEW QUESTION 20
Refer to the exhibit.
If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?
- A. Areas with the signal strength weaker than -68 dB are cut out of the map
- B. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
- C. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.
- D. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
Answer: C
NEW QUESTION 21
Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)
- A. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.
- B. DARRP measurements can be scheduled to occur at specific times.
- C. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.
- D. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.
Answer: B,D
Explanation:
According to Fortinet training: "When using DARRP, the AP selects the best channel available to use based on the scan results of BSSID/receive signal strength (RSSI) to AC" and "To set the running time for DARRP optimization, use the following CLI command within the wireless controller setting: set darrp-optimize {integer}. Note that DARRP doesn't do continuous spectrum analysis..."
NEW QUESTION 22
Refer to the exhibits.
Exhibit A
Exhibit B
A wireless network has been created to support a group of users in a specific area of a building. The wireless network is configured but users are unable to connect to it. The exhibits show the relevant controller configuration for the APs and the wireless network.
Which two configuration changes will resolve the issue? (Choose two.)
- A. For both interfaces in the wtp-profile, configure vap-all to be manual
- B. Disable intra-vap-privacy for the Authors vap-wireless network
- C. For both interfaces in the wtp-profile, configure set vaps to be "Authors"
- D. Increase the transmission power of the AP radio interfaces
Answer: A,C
NEW QUESTION 23
When deploying a wireless network that is authenticated using EAP PEAP, which two configurations are required? (Choose two.)
- A. An X.509 to authenticate the authentication server
- B. An X.509 certificate to authenticate the client
- C. A WPA2 or WPA3 Enterprise wireless network
- D. A WPA2 or WPA3 personal wireless network
Answer: A,C
NEW QUESTION 24
Refer to the exhibit.
What does the asterisk (*) symbol beside the channel mean?
- A. Indicates channels that can be used only when Radio Resource Provisioning is enabled
- B. Indicates channels that are subject to dynamic frequency selection (DFS) regulations
- C. Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)
- D. Indicates channels that cannot be used because of regulatory channel restrictions
Answer: B
NEW QUESTION 25
What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?
- A. DHCP
- B. Multicast
- C. Broadcast
- D. Static
Answer: A
NEW QUESTION 26
When deploying a wireless network that is authenticated using EAP PEAP, which two configurations are required? (Choose two.)
- A. A WPA2 or WPA3 Enterprise wireless network
- B. An X.509 to authenticate the authentication server
- C. An X.509 certificate to authenticate the client
- D. 509 certificates and work for connections that use Secure Socket Layer/Transport Level Security (SSL/TLS). Both client and server certificates have additional requirements.
- E. A WPA2 or WPA3 personal wireless network
Answer: B,C
NEW QUESTION 27
As standard best practice, which configuration should be performed before configuring FortiAPs using a FortiGate wireless controller?
- A. Create wireless LAN specific policies
- B. Set the wireless controller country setting
- C. Create a custom AP profile
- D. Preauthorize APs
Answer: B
NEW QUESTION 28
Which factor is the best indicator of wireless client connection quality?
- A. The channel utilization of the channel the client is using
- B. Upstream link rate, the connection rate for the client to the AP
- C. Downstream link rate, the connection rate for the AP to the client
- D. The receive signal strength (RSS) of the client at the AP
Answer: D
Explanation:
SSI, or "Received Signal Strength Indicator," is a measurement of how well your device can hear a signal from an access point or router. It's a value that is useful for determining if you have enough signal to get a good wireless connection.
NEW QUESTION 29
Which two phases are part of the process to plan a wireless design project? (Choose two.)
- A. Hardware selection phase
- B. Project information phase
- C. Site survey phase
- D. Installation phase
Answer: B,C
NEW QUESTION 30
Which two roles does FortiPresence analytics assist in generating presence reports? (Choose two.)
- A. Comparing current data with historical records
- B. Predicting the number of guest users visiting on-site
- C. Reporting potential threats by guests on site
- D. Gathering details about on site visitors
Answer: A,D
NEW QUESTION 31
......
Latest 100% Passing Guarantee - Brilliant NSE6_FWF-6.4 Exam Questions PDF: https://www.surepassexams.com/NSE6_FWF-6.4-exam-bootcamp.html
Practice Examples and Dumps & Tips for 2023 Latest NSE6_FWF-6.4 Valid Tests Dumps: https://drive.google.com/open?id=1V4ZNluiCMpdLuoXFUrzLnR13jbd2_Swt